User's Manual

Chapter 2, Advanced Configuration
22 TR-WMX-5.8 Outdoor Subscriber Unit User's Guide
2.3 Entering Network Setup Settings
The Configurator provides two menu selections for entering network setup settings:
 TCP/IP lets you set the MAC address and IP mode for the TR-WMX-5.8. See section 2.3.1.
 VLAN lets you set the virtual LAN (VLAN) settings for the TR-WMX-5.8. See section 2.3.2.
If you change any of the settings on these pages, click the Apply button at the bottom
of the page to reboot the TR-WMX-5.8 and have your settings take effect.
2.3.1 Entering TCP/IP Settings
Clicking the TCP/IP link under Network Setup in the left pane of the Configurator
displays the TCP/IP Settings page. Use this page to select the wireless settings for the
TR-WMX-5.8. Figure 2-4 shows this page, and Table 2-3 describes the fields and buttons
on it.
By default, the TR-WMX-5.8 is set to secondary managed mode. In this mode,
the IP Mode settings in Table 2-3 are set automatically and the fields are
unavailable. If you switch to unmanaged mode (No Secondary Management),
you can specify these settings manually. To change between the two modes,
use Secondary Management Connection Support on the Wireless Settings
page (see section 2.2.1).
If you change the unit’s MAC address from those assigned when the unit was
shipped and noted on the Subscriber Unit label, please ensure that the MAC of
the Wireless MAC address is a lower number than the Wired MAC address.