User's Manual

Chapter 1, Basic Installation
12 TR-WMX-5.8 Outdoor Subscriber Unit User's Guide
Figure 1-7. TCP IP Settings
Table 1-3. TCP/IP Settings
Parameter Choose This Setting
Wireless Management IP Address Secondary managed mode: This value is set automatically and the field is
unavailable.
Unmanaged mode: Set this parameter to an unused value in the subnet to which
the base station is connected.
Wireless Management Net Mask Secondary managed mode: This value is set automatically and the field is
unavailable.
Unmanaged mode: Set this value to match that of the subnet to which the base
station is connected.
Management Route Gateway Secondary managed mode: This value is set automatically and the field is
unavailable.
Unmanaged mode: Set this value to be the router on the subnet to which the base
station is connected.
3. Click the Apply button. When the next page appears, click the Reboot button to
reboot the TR-WMX-5.8 and put your saved settings into effect.
Rebooting disconnects the TR-WMX-5.8 and any connections currently running.
It may take 60 seconds before the TR-WMX-5.8 s running and accessible again.
The Status LED flashes while the unit reboots and goes ON when the unit
completes the reboot process.
Congratulations! You have now completed the installation procedures for your TR-WMX-
5.8 node. Your TR-WMX-5.8 unit is now ready for use.
By default, security is disabled on the TR-WMX-5.8. To enable security, see
section 2.2.2.