User's Manual

Chapter 1, Basic Installation
10 TR-WMX-5.8 Outdoor Subscriber Unit User's Guide
Table 1-2. Wireless Settings
Parameter Choose This Setting
Group ∂ Parameters in Figure 1-6
Channel Bandwidth (MHz) Select 3.5MHz (default) 5MHz, 7MHz, or 10MHz whichever
best suits your application’s bandwidth needs and is allowed
by your license. The base station must be set to the same
bandwidth.
Secondary Management Connection Support Confirm that the default setting (Secondary Management
Support) is selected. If not, select it.
Initial Ranging Burst Inverting Confirm that the default setting (Software Auto) is selected. If
not, select it.
Adaptive Modulation (DBPC) Confirm that the default setting (Auto using CINR thresholds)
is selected. If not, select it.
Frequency (KHz) Sets the frequency, in kHz. Range is 5725000 – 5925000 in
increments of 500kHz. Default is 5725000 (5.72 GHz).
Initial Delay Correction Value Confirm that the default setting (0) is selected. If not, select it.
Max TX Power (dBm) This value should match the TR-WMX-5.8 antenna.
Examples:
• TR-WMX-5.8-14: specify a value that is 14db less than
the max EIRP setting. If the max EIRP setting is 30dBm,
for example, set Max Tx Power to 16dBm.
• TR-WMX-5.8-17: specify a value that is 17db less than
the max EIRP setting. If the max EIRP setting is 30dBm,
for example, set Max Tx Power to 13dBm.
• TR-WMX-5.8-20: specify a value that is 20db less than
the max EIRP setting. If the max EIRP setting is 30dBm,
for example, set Max Tx Power to 10dBm.
The Max Tx Power value cannot exceed 20dBm. Default
setting is 20.
Note: When setting the Max Tx Power value, do not exceed
the max EIRP allowed by your license. When adding the
values for Tx Antenna Gain and Max Tx Power, the sum of
these values must equal or be less than the max EIRP that
your license allows. The gain of the internal antenna is 17dB,
requiring the Max Tx Power to be set to (max EIRP – 17).
Min Tx Power (dBm) Confirm that the default setting (-10) is selected. If not, select
it.
Rx Antenna Gain (1/4dB step) Confirm that the default setting (0) is selected. If not, select it.
Tx Antenna Gain (1/4dB step) Confirm that the default setting (0) is selected. If not, select it.
Group • Parameters in Figure 1-6
MAC Message Strict Checking Confirm that the default setting (Disable) is selected. If not,
select it.
Pack Enable for Primary CID Confirm that the default setting (Enable) is selected. If not,
select it.
Fragment Enable for Primary CID Confirm that the default setting (Enable) is selected. If not,
select it.