User's Manual

Configuring the TR-WMX-5.8
TR-WMX-5.8 Outdoor Subscriber Unit User's Guide
7
1.5 Configuring the TR-WMX-5.8
After installing the TR-WMX-5.8, use the procedures in the following sections to
configure it using its Configurator.
1.5.1 Logging in to the Configurator
Your TR-WMX-5.8 provides a Web-based Configurator for performing advanced
configuration activities. After you install your TR-WMX-5.8, use the following procedure
to launch the Configurator.
1. Use an Ethernet cable to connect the Ethernet port on the PoE to a network-
interface card (NIC) in a PC or network hub.
The TR-WMX-5.8 Ethernet port is equipped with an auto-sensing Ethernet port
that allows both regular and cross-over cables to be used.
2. Start your Web browser and point it to one of the following default IP addresses:
http://192.168.101.151 or http://192.168.0.1. The Login page in Figure
1-4 appears, with your cursor in the User name field.
The default IP address is the same for all TR-WMX units. Therefore, do not
simultaneously connect multiple unconfigured TR-WMX units to a common
Local Area Network (LAN) and try to access them using the default IP address.
To connect to the Configurator, your PC’s IP address must be on the same
subnet (192.168.101.xxx, where xxx is a number from 1 to 253) as the TR-
WMX-5.8, and the PC’s netmask must be set to 255.255.255.0.