User's Manual

Configuring the TR-WMX-3.5
TR-WMX-3.5 Subscriber Unit User's Guide
13
Parameter Choose This Setting
Enable 0 Symbol HDD Patch Confirm that the default setting (Disable) is selected. If not,
select it.
Group ÷ Parameters in Figure 1-7
BSID and Mask Use the standard format for MAC addresses (six 2-digit
hexadecimal numbers separated by colons) to enter the base
station ID. Example: “12:34:56:78:9a:bc”. You can enter up to
8 base station addresses, separating each by pressing the
Enter key. To match all BSIDs, mask out the lower 3 bytes.
"00:00:00:00:00:00 00:00:00:00:00:00" .
1.5.3 Specifying Network Setup Settings
After specifying wireless settings, use the following procedure to specify the network
setup settings.
1. In the left pane, under Network Setup, click TCP/IP. The TCP/IP Settings page
appears (see Figure 1-8).
2. If the TR-WMX-3.5 is set to unmanaged mode (No Secondary Management), set the
parameters in Table 1-3 (these parameters are highlighted in orange in Figure 1-8).
Otherwise, skip to step 3 below.
By default, the TR-WMX-3.5 is set to use secondary managed mode. In this
mode, the settings in Table 1-3 are set automatically and the fields are
unavailable. If you switch to unmanaged mode (No Secondary Management),
you can specify the settings in Table 1-3 manually. To change between the
two modes, use Secondary Management Connection Support on the Wireless
Settings page (see section 2.2.1).
Figure 1-8. TCP IP Settings
Table 1-3. TCP/IP Settings
Parameter Choose This Setting
Wireless IP Address Secondary managed mode: This value is set automatically and the field is