User's Manual

24 TR-WMX-2.X Subscriber Unit User's Guide
1.6.2 Status LEDS
The rear of the TR-WMX-2.X has 9 LEDs that show the unit’s status. Table 1-5 describes
the functions of the LEDs.
The TR-WMX-2.X status LEDs can be disabled from the Administrative Settings
page (see section 4.4.3).
Table 1-5. TR-WMX-2.X LEDs
LED
Description
Radio
ON = connection with a base station has been established.
OFF = connection with a base station has not been established.
LAN
ON = a connection to the Ethernet port has been established.
Flash = connection is in use.
OFF = a connection to the Ethernet port has not been established.
Status
ON = TR-WMX-2.X is fully operational.
Blink = TR-WMX-2.X is booting or shutting down.
Signal
Indicates the received signal strength from a base station.
1 LED blinking = there is no link between the TR -WMX-2.X and the base station.
1 LED ON = RSSI ≤ -96dBm
2 LEDs ON = -95dBm ≤ RSSI -86 dBm
3 LEDs ON = -85dBm ≤ RSSI ≤ -76 dBm
4 LEDs ON = -75dBm ≤ RSSI ≤ -61 dBm
5 LEDs ON = RSSI ≥ -60 dBm
Power
ON = TR-WMX-2.X is receiving power.
OFF = TR-WMX-2.X is not receiving power.