User's Manual

16 TR-WMX-2.X Subscriber Unit User's Guide
Tabelle 1-2. Stiftbelegungen für den TR-WMX-2.X 10/100 Ethernet-Anschluss
Stift
Signal
Standard-Drahtfarbe
1
Tx+
Weiß/Orange
2
Tx -
Orange
3
Rx+
Weiß/Grün
4
PoE V+
Blau
5
PoE V+
Weiß/Blau
6
Rx-
Grün
7
Gnd
Weiß/Braun
8
Gnd
Braun
1.5 Configuring the TR-WMX-2.X
After installing the TR-WMX-2.X, use the procedures in the following sections to
configure it using its Configurator.
1.5.1 Logging in to the Configurator
Your TR-WMX-2.X provides a Web-based Configurator for performing advanced
configuration activities. After you install your TR-WMX-2.X, use the following procedure
to launch the Configurator.
1. Use an Ethernet cable to connect the Ethernet port on the PoE to a network-
interface card (NIC) in a PC or network hub.
The TR-WMX-2.X Ethernet port is equipped with an auto-sensing Ethernet port
that allows both regular and cross-over cables to be used.
2. Start your Web browser and point it to one of the following default IP addresses:
http://192.168.101.151 or http://192.168.0.1. The Login page in Figure
1-7 appears, with your cursor in the User name field.
The default IP address is the same for all TR-WMX units. Therefore, do not