User's Manual

TR-WMX-2.X Subscriber Unit User's Guide
7
IMPORTANT: This device must be grounded. Connect the green grounding
wire on the Radio and the POE to a known good earth ground, as outlined in the
National Electrical Code. See Figure 1-3 for further details.
3. To power the TR-WMX-2.X:
– Connect one end of a Category 5 Ethernet LAN cable to the TR-WMX-2.X Ethernet
port.
– Connect the other end of the cable to the port labeled CPE on the supplied PoE
adapter.
– Connect the supplied AC adapter to the PoE adapter.
– Plug the AC adapter into an electrical outlet. The TR-WMX-2.X performs its self-
test for about 30 seconds. Then the TR-WMX-2.X LEDs show the status of the unit
(see section 1.6.2).
Do not connect a device other than the TR-WMX-2.X to the CPE port. Network
equipment that does not support PoE can be damaged permanently by
connecting to a PoE source. Most Ethernet interfaces on PCs, laptop/notebook
computers, and other network equipment (such as Ethernet switches and
routers) do not support PoE.
4. If your unit has an external antenna, turn off power to the TR-WMX-2.X, then attach
the antenna to the TR-WMX-2.X antenna connector. Mount the antenna in a location
that provides the best communication with the base station.