User's Manual

6 TR-WMX-2.X Subscriber Unit User's Guide
Step 7:
Fit the boot cover over the 4 studs and the gasket.
Secure with 4 keps nuts. Tighten with a 3/8”
wrench until the gasket is at least 50% compressed.
Step 8:
Make sure the cap nut of the strain relief is
tightened properly to ensure a weather-proof seal.
IMPORTANT! Hand tighten only. Do not over
tighten as you may damage the weather-tight seal
of the strain relief.
Mounting the Radio
Be sure to turn off power to the TR-WMX-2.X before mounting the antenna.
Step 9:
Attach the mounting bracket to the pole using the
U-bolt. Secure the U-bolt with the lock washers
and the nuts. Align if necessary, and then tighten
the nuts enough to prevent any movement.
Step 10:
Fit the radio to the mounting bracket. Secure the
radio with keps nuts.
IMPORTANT! The strain relief must be always
facing the ground.
Step 11:
Using a #6 green grounding wire, connect the
grounding lug on the radio to a proper earth
ground as outlined in the National Electric Code.