User's Manual

TR-WMX-2.X Subscriber Unit User's Guide

Step 2:

Using a 3/4” wrench, tighten the strain relief until it

touches the boot cover.

IMPORTANT! Use hand tools only. Do not over

tighten.

Step 3:

Put the cap nut back over the strain relief and insert

the Cat 5 cable through it. Wire the cable following

the EIA/TIA T568B standard, and attach the RJ-45

connectors to each end of the cable.

Step 4:

If you purchased the device with a dual port cover,

repeat steps 1, 2, and 3 for the second port.

IMPORTANT! If you are not going to use the second

port, insert the strain relief into the boot cover and

tighten the cap nut to ensure a weather tight seal, as

shown in the picture.

Step 5:

Place the gasket—with the adhesive side facing up

over the 4 studs around the port of the radio. Flatten

thegasket ensuring there are no gaps. Remove the

backing.

Step 6:

Plug the Cat 5 cable inserted in the boot cover

into the port. Remember to place the boot cover

according to the desired polarization, so that the

strain relief faces the ground.