User's Manual

4 TR-WMX-2.X Subscriber Unit User's Guide
1.4 Installing the TR-WMX-2.X (English)
The TR-WMX-2.X can be mounted either horizontally or vertically. Before you install the
unit, determine whether the TR-WMX-2.X will be mounted horizontally or vertically.
You must read and understand the following safety instructions before installing
this device:
 This radio’s grounding system must be installed according to Articles 810-15,
810-20, 810-21 of the National Electric Code, ANSI/NFPA No. 70-1993. If you
have any questions or doubts about your antenna’s grounding system, contact a
local licensed electrician.
 Never attach the grounding wire while the device is powered.
 If the ground is to be attached to an existing electrical circuit, turn off the circuit
before installing the radio.
 Use the Tranzeo Power over Ethernet (POE) adapter only with approved
Tranzeo models. The Tranzeo POE must also be grounded to a house ground via
a permanent fixture according to local codes.
 Never install radio equipment, surge suppressors or lightning protection during a
storm.
 Installation of the boot gasket is required for compliance with agency approvals
1.4.1 Installing the Outdoor Unit
The following procedure describes how to install the TR-WMX-2.X Outdoor Subscriber
Unit.
1. Mount the TR-WMX-2.X at the desired location.
2. Attach the boot cover, L bracket, and U bolt to the TR-WMX-2.X, as per the below
procedure:
Installation of the Ethernet Cable and boot Cover
Step 1:
Insert the strain relief, without the cap nut, into the
port opening of the boot cover.