User's Manual
151515
This document is intended for Public Distributio n
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Chapter 3: Configuration
3-15 TR-Multi Series
Tranzeo Wireless Technologies
Router Mode
The following features are available if you select Router mode in the Network
Configuration window.
From this window you can access specific windows to configure the DHCP
Server, QoS, Static Routes, Port Filtering, and Port Forwarding. If the feature is
available, it will appear like a link. T o open an item, just click on it. These features
are described in the next pages.
Note: Many Ethernet devices do not auto-negotiate properly. If you see large
numbers of dropped pings, you may have collisions. Try locking the device at 10 /
Half as a troubleshooting step. If the packet losses stop, step up to 100 / Half. If
the device the radio is connecting cannot support 100 / Half, you should replace
the device or place a switch in line.
MTU: The Maximum Transmission Unit (MT U) refers to the
size of the largest packet that the router can pass. The
default value is 1500 bytes. If PPPoE is used, you
should change the MT U to match the PPPoE server,
typically 1492 bytes.
Allow Pinging: Enables ping responses on WAN interface.
Allow Access to Web
Server:
Allows access from WAN interface or change the port
the WAN server responds to web server requests.
Note: Access to web server from LAN interface is
always enabled and set at port 80.
IP Mode: You can select to use Static IP, DHC P Client
(dynamic), or PPPoE. If no PPPoE server is found,
you may not be able to access the radio from the WAN
side, but you will still be able to get access from the
LAN interface.
LAN: Enter the information related to the LAN interface: IP
address and subnet mask.
DHCP Server: Check the box and click Apply to enable this feature.
Click on the item (which now appears in blue) to open
the DHCP Server configuration window.
Routing: Enables NAT , QoS, and Static Routes. NAT should
always be enabled when using private addressing.
Click on QoS or Static Routes to configure.
Port Management: Check the box and click Apply to enable port filtering
and port forwarding. Click on any item to open the
configuration window.