User's Manual

Chapter 8: System Settings
TR0153 Rev. E1 65
CLI
The OnRamp configuration capability is controlled by the ‘provisioning.enable’ parameter in the
‘sys’ interface. Set this parameter to ‘0’ to disable configuration through OnRamp, as shown in
the example below.
> use sys
sys> set provisioning.enable=0
Web GUI
The OnRamp configuration capability is set on the “OnRamp” tab on the “Security” page (see
Figure 35).
Figure 35. OnRamp configuration access
8.17 CLI Timeout
The CLI will automatically log out a user if the interface has remained inactive for a certain
length of time. The time, in seconds, that a shell must remain inactive before a user is
automatically logged out is set with the ‘shell.timeout’ parameter in the ‘sys’ interface, as
shown in the example below. The maximum idle time that can be set is 21600 seconds (6
hours).
> use sys
sys> set shell.timeout=300