User's Manual

Chapter 6: Status Information
TR0153 Rev. E1 40
Links labeled “(change)” are shown next to the settable parameters. These links take you to
the appropriate page to change the setting.
6.2 Interface Status
Traffic and neighbor information for the mesh, virtual AP, and wired interfaces are available on
the “Status” tab of the “Status” page. Select the appropriate interface for which you wish to
view information from the row of tabs below the primary tab row.
6.2.1 Mesh and Virtual AP Interfaces
The sub-tabs display status information about the mesh and virtual AP interfaces. Data
statistics information for the interface are displayed, showing received and transmitted data in
terms of bytes and packets.
In the case of the “mesh” sub-tab, the neighboring mesh devices that this device can
communicate directly with are displayed. On the “wlan” sub-tabs, the client devices connected
to the virtual APs are displayed. The following information is displayed for each mesh neighbor
or client device:
• MAC address
• IP address
• Quantity of data received from the neighbor/client device and transmitted to the
neighbor/client device
• Received signal strength (RSSI) in dBm and in parentheses the associated signal level
based on a noise floor of -95dBm
• Time since last reception from the device
• A summary of the capabilities of the client device’s radio card