User's Manual

Chapter 5: Initial Configuration of an EnRoute500
TR0153 Rev. E1 37
After these settings have been changed, the EnRoute500s will be able to form a mesh
neighborhood so that further configuration can be done from a central location, using the
connectivity of provided by the mesh. This minimal configuration must be performed prior to
deployment, but all other configuration can be carried out after deployment.
To simplify initial configuration, the web GUI has a page that allows the user to change all the
parameters listed in this section on a single page. This page can be accessed by clicking on
the ‘Minimal configuration’ link in the web interface navigation bar on the left side of the web
interface.