User's Manual

Chapter 20:Firmware Management
TR0153 Rev. E1 152
Figure 70. Updating firmware on all devices in a mesh neighborhood
Follow the procedure below to upgrade the devices in a mesh neighborhood:
1. Select the firmware version you want to upgrade to from the “Firmware on Server” box
2. Click on the button with the arrow to the right of the “Firmware on Server” box. This will
begin the download process of the firmware from the Tranzeo upgrade server to the
non-volatile memory on the EnRoute500. While the firmware is downloading, it will be
shown in blue in the “Firmware on Gateway Node” box.
If the completion percentage does not update, click on the “Upgrade Node” tab to
update it.
3. When the download has been completed, verify that all the devices you wish to update
are listed under the “Nodes Associated with this Gateway” heading. If they are proceed
to the next step.
4. Select the firmware you wish to upgrade to from the “Firmware on Gateway Node” box.
5. Click on the “Copy to All” button. The upgrade image will be copied to the devices in the
mesh that do not already have it. Text indicating progress will be displayed next to the
device IP address under the “Nodes Associated with this Gateway” heading (“files being
copied”, “copy completed”, and finally “READY TO BE UPGRADED”).
6. Again, select the firmware you wish to upgrade to from the “Firmware on Gateway
Node” box.