User's Manual

Chapter 15: Controlling Access to the EnRoute500
TR0153 Rev. E1 115
> use firewall
firewall> set node.allowc2c.eth0=yes
Web GUI
The client isolation parameters can be set via the web interface using the “Connections” sub-
tab under the “Firewall” tab on the “Security” page (see Figure 49). By setting an interface’s
client isolation parameter to ‘yes’, client devices connecting to that interface will not be able to
communicate with any other client devices in the mesh.
Figure 49. Connection-related firewall settings
Note that devices connected to different interfaces can only communicate with each other if
client-to-client isolation is disabled for both interfaces.
Client-to-client isolation is only enabled if the EnRoute500 firewall
(firewall.node.enable) is enabled (section 15.1).