User's Manual

AirSync 2.2 Quick Configuration Guide – Tranzeo pBS 3
Preface
This guide provides all the information you need to configure the Tranzeo Pico Base
Station (pBS) and TR-WMX WiMAX Subscriber Unit to enable end-to-end WiMAX
connectivity using AirSync. If you prefer detailed instructions, please refer to the
Proximetry AirSync Practical User’s Guide.
The following figure shows an example of a configuration where the Subscriber Unit is
connected to the uplink (WAN) interface on an Ethernet router, hub, or switch. In this
configuration, the Subscriber Unit communicates wirelessly with a Base Station using
its WiMAX interface, while communicating at 10/100 Mbps with the attached Ethernet
device. The Subscriber Unit also receives its power from the Ethernet connection,
eliminating the need to run a power cable to the Subscriber Unit. In this way, the
Ethernet device serves as the bridge between the attached computers and the
Subscriber Unit.