User Guide

AirSync 2.2 Quick Configuration Guide – Tranzeo pBS 3
Preface
This guide provides all the information you need to configure the Tranzeo Pico Base
Station (pBS) and TR-WMX WiMAX Subscriber Unit to enable end-to-end WiMAX
connectivity using AirSync. If you prefer detailed instructions, please refer to the
Proximetry AirSync Practical User’s Guide.
The following figure shows an example of a configuration where the Subscriber Unit is
connected to the uplink (WAN) interface on an Ethernet router, hub, or switch. In this
configuration, the Subscriber Unit communicates wirelessly with a Base Station using
its WiMAX interface, while communicating at 10/100 Mbps with the attached Ethernet
device. The Subscriber Unit also receives its power from the Ethernet connection,
eliminating the need to run a power cable to the Subscriber Unit. In this way, the
Ethernet device serves as the bridge between the attached computers and the
Subscriber Unit.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 32 dBi. Antennas not included in this list or having a gain greater than 32 dBi
are strictly prohibited
for use with this device.
The required
antenna impedance
is 50 ohms.