User Guide

WiMAX Quick Configuration Guide 21
Magic Wavesat Synch parameter on the pBS and the Initial Delay
Correction Value on the SS.
Figure 11. Configuration subtab on Device Interfaces Details tab.
The figure above shows the default values to configure the Pico
Base Station to be connected to a single Subscriber Unit. If you wish
to connect more than one Subscriber Unit please modify the Frame
Length to 10 or 20 ms. 10ms is the recommended value. Although
the latency will increase compared to 5ms frames, the supported
throughput will increase. In addition, change the Minimum Size of
First Burst value under the MAC_GRP tab. The recommended burst
size values are shown below in Table 5: Minimum Size of First Burst
for multiple Subscriber Units.
Table 5: Minimum Size of First Burst for multiple Subscriber Units.
Number of
Subscriber Units
Minimum Size
of First Burst
1 25
2 27
3 28
4 30
5 31
6 33