User Guide

WiMAX Quick Configuration Guide 14
1.3.3 Specify Network Setup Settings
After specifying wireless settings, use the following procedure to specify the network
setup settings.
1. In the left pane, under Network Setup, click TCP/IP. The TCP/IP Settings
page appears (see Figure 6).
2. When the Subscriber Unit is set to unmanaged mode (No Secondary
Management set on the Wireless page) the IP Mode will be displayed as
static on the TCP/IP page. Confirm IP mode is static and set the parameters
in Table 2 (these parameters are highlighted in orange in Figure 6).
Otherwise, skip to step 3 on the next page.
Figure 6. TCP IP Settings page.
Table 2. TCP/IP Settings
Parameter Choose This Setting
Wireless Management IP
Address
Secondary management mode: This value is set
automatically and the field is unavailable.
Unmanaged mode: Set this parameter to an unused value
in the subnet to which the Pico Base Station is connected.
Wireless Management Net
Mask
Secondary management mode: This value is set
automatically and the field is unavailable.
Unmanaged mode: Set this value to match that of the
subnet to which the Pico Base Station is connected.
Management Route Gateway Secondary managed mode: This value is set automatically
and the field is unavailable.