Manualshelf

User Guide

ManualsBrandsTranzeo Wireless Technologies ManualsElectronics5.8 GHz WIRELESS BASE STATION
11121314151617181920
WiMAX Quick Configuration Guide 13
Parameter Choose This Setting
Rx Antenna Gain (1/4dB step) Confirm that the default setting (0) is selected. If not,
select it. This can be adjusted to match the gain of the
antenna used, however the default setting of 0 will
enable connectivity in all cases.
Tx Antenna Gain (1/4dB step) Confirm that the default setting (0) is selected. If not,
select it. This can be adjusted to match the gain of the
antenna used, however the default setting of 0 will
enable connectivity in all cases. The SS uses the same
antenna for Tx and Rx.
Group ī˜‚ Parameters in Figure 5
For Least Robust DIUC as
LSB/MSB and DCD CCC as
MSB/LSB
Confirm that the default setting (Enable) is selected. If
not, select it.
MAC Message Strict Checking Confirm that the default setting (Disable) is selected. If
not, select it.
Pack Enable for Primary CID Confirm that the default setting (Enable) is selected. If
not, select it.
Fragment Enable for Primary CID Confirm that the default setting (Enable) is selected. If
not, select it.
Tx Overrun Fix Confirm that the default setting (Disable) is selected. If
not, select it.
QoS Admitted Bit Confirm that the default setting (Disable) is selected. If
not, select it.
QoS Tx Policy Checking Confirm that the default setting (Disable) is selected. If
not, select it.
Enable 0 Symbol HDD Patch Confirm that the default setting (Disable) is selected. If
not, select it.
AFS mode Confirm that the default setting (Disable) is selected. If
not, select it.
Group ī˜ƒ Parameters in Figure 5
BSID and Mask Use the standard format for MAC addresses (six 2-digit
hexadecimal numbers separated by colons) to enter
the Pico Base Station ID. Example:
ā€œ12:34:56:78:9a:bcā€. You can enter up to 8 Pico Base
Station addresses, separating each by pressing the
Enter key. To match a range of BSIDs, in the mask
field use 0 to allow any or f in the digit corresponding
to the BSID value to match. To match any BSID, utilize
a setting of all zeros for both the BSID and Mask:
"00:00:00:00:00:00 00:00:00:00:00:00".