User Guide
WiMAX Quick Configuration Guide 12
Table 1. Wireless Settings
Parameter Choose This Setting
Group Parameters in Figure 5
Channel Bandwidth (MHz) For the 3.5GHz pBS operation select 3.5MHz or 7MHz
(default), whichever best suits your application’s
bandwidth needs and is allowed by your license. The
Pico Base Station must be set to the same bandwidth.
For the 3.65GHz pBS operation select 3.5MHz or 7MHz
(default).
For the 5.8GHz pBS operation the default channel
bandwidth is 10MHz.
Secondary Management
Connection Support
Confirm that the default setting (Secondary
Management) is disabled. If not, select No Secondary
Management.
Initial Ranging Burst Inverting Confirm that the default setting (Software Auto) is
selected. If not, select it.
Adaptive Modulation (DBPC) Confirm that the default setting (Auto using CINR
thresholds) is selected. If not, select it.
Frequency (KHz) Sets the frequency, in kHz. For 3.5GHz operation the
SU range is 3300000 – 3600000 in increments of
250kHz. Default is 3525000 (3.525 GHz). Since the
pBS supports frequencies from 3400000-3600000, only
use frequencies in that range.
For 3.65GHz operation the range is 3650000 –
3675000 in increments of 250kHz, only use
frequencies in that range.
For 5.8GHz operation the range is 5725000 – 5850000
in increments of 500KHz. Since the pBS supports
frequencies from 5740000-5830000, only use
frequencies in that range.
Initial Delay Correction Value Confirm that a default setting of 0 is selected. If not,
select it. This parameter may be adjusted over a range
of 0 to 1000, and in conducted tests may need to be
set to 1000 to support 7MHz channels.
Max TX Power (dBm) The Max Tx Power value cannot exceed 20dBm.
Default setting is 20.
When setting the Max Tx Power value, do not exceed
the max EIRP allowed by your license. When adding
the values for Tx Antenna Gain and Max Tx Power, the
sum of these values must equal or be less than the
max EIRP that your license allows.
Min Tx Power (dBm) Confirm that the default setting (-10) is selected. If
not, select it.