User's Manual
Table Of Contents
- Mechanical Description
- Hardware Installation
- Connecting the Ethernet Cable
- Step 1
- Step 2
- Step 3
- Step 4
- 
- Step 5
- Step 7
- Step 8
- Attaching the Mounting Bracket
- Grounding the Antenna
- Connect the Power Cable
- Dual Ethernet Ports
- HTML Interface
- Passwords
- Information
- Wireless Settings
- Image File Name
- Enabled
- Enabled
- Enable Access Control
- QOS
- Why is coiling the LMR or CAT5 bad?
- What standard does Tranzeo Wireless equipment meet?
- Is lightning damaged covered by the Warranty?
- Where to Ground the device
- Ungrounded Radio
- Grounded Radio
- Best Practices
Step 4
Step 5
Step 7
Repeat steps 2 & 3 to attach the second Ethernet
Cable Lock if you purchased the optional dual
port boot.
Place Sealing Gasket over screws.
Insert the Cat 5 Cable and tighten the Boot
Cover. Be sure to pull enough cable through to
reach the RJ-45 connector with an RJ-45 jack at-
tached. The Gasket must be attached to the
Boot so that it sits between the radio and the
boot.
Hand tighten only. DO NOT OVERTIGHTEN as
you may damage the environment seal.
Remove gasket backing and place boot cover on
radio. This will ensure that you attach the sticky
side of the gasket to the underside of the
Ethernet Boot. Make sure the Gasket is free of
gaps.
Step 6