User's Manual
Table Of Contents
- Mechanical Description
- Hardware Installation
- Connecting the Ethernet Cable
- Step 1
- Step 2
- Step 3
- Step 4
- 
- Step 5
- Step 7
- Step 8
- Attaching the Mounting Bracket
- Grounding the Antenna
- Connect the Power Cable
- Dual Ethernet Ports
- HTML Interface
- Passwords
- Information
- Wireless Settings
- Image File Name
- Enabled
- Enabled
- Enable Access Control
- QOS
- Why is coiling the LMR or CAT5 bad?
- What standard does Tranzeo Wireless equipment meet?
- Is lightning damaged covered by the Warranty?
- Where to Ground the device
- Ungrounded Radio
- Grounded Radio
- Best Practices
Connecting the Ethernet Cable
Step 1
Step 2
Step 3
Place the Ethernet Boot Cover over the end of
your Cat 5 cable.
Attach Ethernet Cable Lock on side of the
Ethernet Boot. This is easiest to do before you
attach the RJ-45 Jack.
Tighten using a ¾” wrench or socket. Tighten
until the Cable Lock touches the Boot as shown
in Step 3.