User's Manual
Table Of Contents
- Mechanical Description
- Hardware Installation
- Connecting the Ethernet Cable
- Step 1
- Step 2
- Step 3
- Step 4
- 
- Step 5
- Step 7
- Step 8
- Attaching the Mounting Bracket
- Grounding the Antenna
- Connect the Power Cable
- Dual Ethernet Ports
- HTML Interface
- Passwords
- Information
- Wireless Settings
- Image File Name
- Enabled
- Enabled
- Enable Access Control
- QOS
- Why is coiling the LMR or CAT5 bad?
- What standard does Tranzeo Wireless equipment meet?
- Is lightning damaged covered by the Warranty?
- Where to Ground the device
- Ungrounded Radio
- Grounded Radio
- Best Practices
Mechanical Description
LED panel of the Wireless LAN Smart Access Point
The following table provides an overview of each LED activity:
LED Definition Activity Description
In AP mode the signal lights indicate the following:
Power Supply
ONLY use the power adapter supplied with the TR-49. Otherwise, the product may be damaged.
Label Color Indicators
POWER Red
On: Powered On
Off: No Power
LAN Green
On: Ethernet Link
Flashing : Ethernet Traffic
Off: No Ethernet Link
Radio Amber
On: Radio Link
Flashing Radio Activity
Off: No Radio Link
Signal Red/Amber/Green In CPE mode, light up in sequence to indicate signal strength
Color Indicators
Red
On: WEP/128 Enabled
Flashing: WEP/64 Enabled
Off: WEP Off
Amber
On: WPA/AES Enabled
Flashing : WPA/TKIP Enabled
Off: WPA Off
Amber
No Function in 4.9
Green
On: ACL Enabled
Off: ACL Off
Green
On: WDS Enabled
Off: WDS Off