User's Manual
Table Of Contents
- Mechanical Description
- Hardware Installation
- Connecting the Ethernet Cable
- Step 1
- Step 2
- Step 3
- Step 4
- 
- Step 5
- Step 7
- Step 8
- Attaching the Mounting Bracket
- Grounding the Antenna
- Connect the Power Cable
- Dual Ethernet Ports
- HTML Interface
- Passwords
- Information
- Wireless Settings
- Image File Name
- Enabled
- Enabled
- Enable Access Control
- QOS
- Why is coiling the LMR or CAT5 bad?
- What standard does Tranzeo Wireless equipment meet?
- Is lightning damaged covered by the Warranty?
- Where to Ground the device
- Ungrounded Radio
- Grounded Radio
- Best Practices
Statistics
The Statistics Screen is divided into 3 main areas, UMAC
*
, LMAC
*
and Ethernet. For Radio Troubleshooting, the UMAC
statistics are likely the most useful. The UMAC breaks down the statistics into Good and Bad Packets, whereas LMAC defines
why the packets are bad.
The statistics are further divided into TX, RX and INT. TX and RX values are useful to ISPs and other users. The INT (Internal)
stats are intended for use by Tranzeo Wireless Technical Support.
* Technical Info:
UMAC or Upper MAC functions occur in the Unit’s Processor.
LMAC or Lower MAC functions occur in the Radio Chipset.
You can click onto each speed level and see how the traffic breaks down. In the TX statistics, there should little to no Tries at
Series 2, 3 or 4. The radio will try to send a packet 4 times at Series 1, and then tries the next series 4 times. In the RX stats, you
should look for Bad CRC’s and Bad Decrypts for signs of RF interference or Fresnel interference links.
Bad PHY’s generally are caused when the radio is unable to decode the packets due to noise.
Note: Communication between APs and Stations always occurs at the lowest rate. In a normal link you should see a fair number
of transactions at the lowest rate.