User's Manual
Table Of Contents
- Mechanical Description
- Hardware Installation
- Connecting the Ethernet Cable
- Step 1
- Step 2
- Step 3
- Step 4
- 
- Step 5
- Step 7
- Step 8
- Attaching the Mounting Bracket
- Grounding the Antenna
- Connect the Power Cable
- Dual Ethernet Ports
- HTML Interface
- Passwords
- Information
- Wireless Settings
- Image File Name
- Enabled
- Enabled
- Enable Access Control
- QOS
- Why is coiling the LMR or CAT5 bad?
- What standard does Tranzeo Wireless equipment meet?
- Is lightning damaged covered by the Warranty?
- Where to Ground the device
- Ungrounded Radio
- Grounded Radio
- Best Practices
This document is intended for Public Distribution 19473 Fraser Way
DHCP Server Configuration
Subnet Mask
Subnet mask for the DHCP pool.
Address Range
Starting Address
The starting address of the DHCP
pool.
The addresses are sequential starting with the
Starting Address.
Number of Addresses
The number of addresses you
want to have in the DHCP pool
Gateway
Select This Unit to use the gate-
way set on the WAN interface of
the radio or select Other to set a
different gateway address.
DNS
WAN-Assigned
Select to use the DNS server
addresses as assigned on the
WAN side.
Static
Select to set DNS servers if
different than those on the
WAN side.
Note: If you select this option but leave the field
blank or set to 0.0.0.0 the client will not get a
DNS server value of 0.0.0.0. You must enter a
value into this field to use a static DNS.
Domain Name and WINS operate the same as DNS.