User's Manual

This document is intended for Public Distribution 19473 Fraser Way
Pitt Meadows, B.C. Canada V3Y 2V4
Phone [phone] Fax [phone]
5 www.tranzeo.com
1/10/2006
QUICK START GUIDE – TR-6000 SERIES
Hardware Installation
Take the following steps to set up your TR-6000 series.
Site Selection: Before installation, determine the TR-6000 series unit’s location. Proper placement of
the unit is critical to ensure optimum radio range and performance. You should perform a Site Survey
to determine the optimal location. Ensure the CPE is within line-of-sight of the Access Point.
Obstructions may impede performance of the unit.
Tools Required to Install
• One 3/8 wrench
• One 3/4 wrench
• One RJ-45 crimper
• A suitable length of Cat 5 cable to bring the signal from the unit to the Power over Ethernet
Adaptor
• 2 RJ-45 Jacks
Before installing, you must determine if the unit will be in the horizontal or vertical orientation. The
TR-6000 series model can be mounted in either orientation. The Ethernet boot should always be
placed so that the cable runs toward the ground for maximum environmental protection.