User's Manual

ManualsBrandsTranwo Technology ManualsElectronicsWiFi Module



WiFiModule

MWF‐5201

Specifications



Version:1.0



TRANWO TECHNOLOGY CORP. www.tranwo.com

No. Version Description Date Writer

1 1.0 Initial 2014‐06‐05 IVONA

   



No.236, Sec.3, Huanbei Rd., Jubei Cit

y, Hsinchu County 30265, Ta

iwan

Tel：886-3-553-5326 Fax：886-3-553-5283

Summary of content (6 pages)

PAGE 1
WiFi Module MWF‐5201 Specifications Version: 1.0 No. Version 1 1.0 Description Date Writer Initial 2014‐06‐05 IVONA TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd.
PAGE 2
WiFi Module MWF‐5201 1. Features  Compliant with IEEE802.11b/g/n、IEEE802.3、IEEE802.3u  Support CSMA/CA、CSMA/CD、TCP/IP、PPPoE、DHCP、ICMP、NAT protocol  Embedded PA/LNA  150Mbps PHY data rate  20Mhz/40Mhz channel width Standard IEEE 802.11 b/g/n、IEEE802.3、IEEE802.3u、CSMA/CA、 CSMA/CD、TCP/IP、PPPoE、DHCP、ICMP、NAT、PPPoE WAN One 10/100M port LAN One 10/100M port Frequency 2.4 ~ 2.4835GHz 11n：135 / 121.5 / 108 / 81 / 54 / 40.5 / 27 / 13.5 Mbps Data Rate 65 / 58.5 / 52 / 39 / 26 / 19.5 / 13 / 6.
PAGE 3
WiFi Module MWF‐5201 2. Interface Definition A. J1 Pin Definition Description Specification Notes 1 3.3V 3.
PAGE 4
WiFi Module MWF‐5201 LDO 25 SPI_CS0 SPI chip select0 26 SPI_CLK SPI clock 27 SPI_MOSI SPI master out slave in 28 3.3V 3.3V DC input pin 29 SOD_1.8V Power supply to 10/100 transformer 30 GND Ground Pin Specification Notes 1 GND Ground 2 ANT1 WiFi Antenna connector 3 GND Ground C. J3 Pin Definition Description Antenna Port 3.
PAGE 5
WiFi Module MWF‐5201 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 6
WiFi Module MWF‐5201 installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co‐location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re‐evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.