User's Manual

Transystem, Inc.
www.transystem.com.tw
1. Before you unpack the box, please check if there are one P07-
1111-2-24 transceiver and one mounting bracket inside.
2. To install the transceiver onto a mast, you will need:
a. An indoor power inserter/adapter (provided by TSI)
b. A 75 ohm coaxial cable (RG 6, RG 7 or RG 11) to run up
the mast to the transceiver
c. A 75 ohm UHF Yagi antenna of proper gain
d. A short 75 ohm (RG-59, RG 6, RG7 or RG 11) coaxial
cable to connect the transceiver with the antenna
3. Installation: (refer to Fig. 1)
a. Install the Yagi antenna onto the mast.
b. On the same mast use the included mounting bracket to
install the transceiver
c. Connect the transceiver’s antenna port to the Yagi antenna
by a short 75 ohm Male-to-male coaxial cable. Use a water-
proof tape to seal the transceiver’s F-connector port.
d. Connect the DC+IF port of the transceiver to where the
wireless modem is indoors by a long 75 ohm coaxial cable.
Also use a water-proof tape to seal the transceiver’s F-
connector port. Note that unless the modem can power the
transceiver through the coaxial cable, you will need to
install the wall mount adapter/power inserter (provided by
TSI) between the transceiver and the modem.
e. Turn on the power adapter and use either the modem’s
utility software or a CATV signal strength meter to align
the Yagi antennas’ direction toward where the headend
antenna site is to get the strongest downlink signal.
f. Fix the antenna direction. Install the necessary anti-
lightning grounding rod to protect lightning strike.