User's Manual

760 GPS Recorder
V0.1
9
2.4 POI confirmation
GPS 760 uses following methods to confirm press of POI button:
Vibrator (default)
Memory capacity LED blinks 3 times (default)
Sound buzzer alarm (Optional)
2.5 Getting Started
Please follow the procedure step by step.
Step 1 Charging Your Battery
Connect your USB cable between 760 and the power source. Charging time is about 3~4
hours and you can charge from PC/ Notebook’s USB HOST or from cigarette-lighter in car or
home adapter.
For the 1st time you use the 760, please charge battery until it is full. Red Power LED will be
On during charging cycle and turns Off once the charging is completed.
Step 2 Turn on your GPS 760 and get position fix
Turn on your GPS 760 by press-and-hold the power button for 2 seconds. Power LED will
turn on after power on sequence is completed. The orange GPS status LED will stays on
before 760 get GPS position fix. Make sure your GPS 760 has clear sky view at this stage of
acquiring satellite signal. Depending on your surroundings, it normally takes around 40
seconds to 1.5 minutes before GPS status starts to blink which means 760 has acquired
necessary satellite signals and get position fix..
Step 3 Log your position
GPS 760 will start logging your position once it locks to satellites signal. It will log and mark