850 User’s Manual Published on 24-Nov-2008
Note and Warning - - - - - 850 uses AAA battery*2. If 850 is used in temperature lower than -10°C or higher than 60°C, its battery capability will decrease. Please leave the 850 far from heat or high temperature environment. In addition, do not expose your 850 in temperature higher than 140°C/60°C. If you do not follow these rules, the battery may become heat, explode or burn itself, and this will lead to very serious damage. While in the hospital, turning off the 850 is recommended.
Table of Contents Chapter1. Before you begin.........................................................................................4 1.1 Introduction..............................................................................................4 1.2 1.3 1.4 1.5 Feature overview ......................................................................................4 Specification..............................................................................................5 Buttons and Description ..........
3.2.1 Connect USB cable between GPS and laptop..........................25 3.2.2 Executing GpsView Program....................................................26 Chapter 4 Using Photo Tagger software ..................................................................30 4.1. Execute and install software utility Photo Tagger ..............................30 4.2. Google Earth...........................................................................................30 4.3. Software Utility --- 850 ...............
Chapter1. Before you begin 1.1 Introduction The TripMate850 features an all-in–one, cost-effective portable GPS logger solution. When you travel in different country, it allows you to record your routes by ways of time/ distance/ speed. The 850 include a one inch LCD, as the real time, moving speed, distance measurement and position information, all of the message always can shown on the LCD. Through user friendly software utility, it can combine the beautiful pictures and record routes show on the map.
1.3 Specification General Frequency L1,1575.42MHz Datum WGS84 C/A Code 1.023Mhz Performance Characteristics Without aid: 3.0m 2D-RMS Without aid: 0.1m/s Velocity Position Accuracy <3m CEP(50%) without Accuracy SA(horizontal DGPS(WAAS,EGNOS,MSAS): 0.05m/s DGPS(WAAS,EGNOS,MSAS) Without aid: <4g : 2.5m Acceleration Timing 50ns RMS DGPS(WAAS,EGNOS,MSAS): <4g Accuracy Reacquisition <1s Hot start 1.5s Warm start 34s Cold start 35s AGPS <15s Time Acquisition: -148dBm Max.
LCD Size 28 x 8.5mm Pixel 128 x 32 pixel Environment Operation -10° to 50° Temperature Interface Fully compliant with USB2.0 Fully compliant with Bluetooth V1.2 12Mbps 0dBm(Typical), Class II USB Bridge SD Micro SD card Bluetooth Up to 10 meters Serial Port Profile(SPP) 2.4GHz~2.4835GHz ISM Band Others 57.5g(with battery) Dimension 72*27x25mm 36.5g(without battery) NMEA GGA,GSA,GSV,RMC Weight (g) *Citation MTK original chipset spec.
1.
1.5 Accessories Congratulations on your purchase of the 850. Before you start using 850, please make sure if your package includes the following items. If any item is damaged or missing, please contact your dealer at once. ◎ ◎ ◎ ◎ ◎ Driver CD x1 USB cable x1 AAA battery x2 Quick start guide x1 Micro SD 256M x1 *Unit package contents may vary depending on countries without prior notice.
Chapter2. Getting started 2.1 Turn on/off 850 Press “POWER” button for 3 sec, LCD screen will show battery, satellite, log memory status. POWER POWER 2.
2.3 Diagram flow ADJUST LOG ON/OFF MEAN ADJUST MEAN ADJUST MEAN MEAN MEAN ADJUST MEAN ADJUST MEAN MEAN MEAN ADJUST MEAN MEAN MEAN MEAN MEAN MEAN MEAN MEAN ADJUST MEAN ENTER MEAN ADJUST MEAN MEAN ADJUST YES As the detail information, please see functional description.
When the 850TripMate is no fixed, the screen will show below image. 2.4 ICON introduce Symbol Category LOG ICON BLUETOOTH ICON Status Function on Device is not into the log mode yet. blinking In LOG mode. on Bluetooth on, but not connected to any Bluetooth devices yet. blinking Bluetooth is connected and ready for data transmission. on Acquiring satellites, GPS position not fixed. blinking GPS position is fixed can start for smart phone navigation.
2.5 Functional description 2.5.1 Battery, Satellite, Log memory Mode < Battery, Satellite, Log memory Mode > ENTER FUNCTION BUTTON MENU LOG ON/OFF Detail Description When you want to start log data, please check up right hand START LOG LOG ON > ENTER corner of the screen is stay in “LOG ON”, and than please press “ENTER” button. The log icon will blink for 1second. After you start the 850, the screen will show log memory from 0% to 100%.
2.5.2 Time Mode < Time Mode > FUNCTION BUTTON Detail Description The time mode is use UTC time and receiver form GPS TIME ADJUST > UTC+1 or ephemeris. You can select location time. After you press ADJUSTMNET UTC-1 > ENTER “ADJUST” button, the screen will show “UTC+1” and “UTC-1”. When the time adjust successfully, please press “ENTER” button. NEXT SECTION 2.5.3 MENU Please press “MENU” button go to next section.
2.5.4 Speed & Direction Mode < Speed & Direction Mode > FUNCTION BUTTON SPEED AND Detail Description In this mode, the 850 will indicator Current speed and direction NONE DIRECTION on the LCD. NEXT SECTION 2.5.5 MENU Please press “MENU” button go to next section. Distance measurement Mode < Distance measurement Mode > FUNCTION BUTTON Begin distance Detail Description Please select "BEGIN", "STOP", or "ERASE" in the same button.
2.5.6 Setting Mode < Setting Mode > FUNCTION BUTTON Detail Description 1. Please press “ADJUST” button go to option of the setting mode. In set mode, include “LANGUAGE”, “LOG MODE”, FURTHER SET ADJUST “SMART LOG”, “LOG MANAGE”, “UNIT SET”, and “DEFAULT”. Allow you further set. NEXT SECTION MENU Please press “MENU” button go to next section. 2.5.6.
2.5.6.2 Log Mode Setting In log mode, you can choose log by time, distance or speed. Please press “ADJUST” button to further set. When you make sure selection, please press “ENTER” button to save set. FUNCTION BUTTON LOG BY TIME ADJUST > ENTER Detail Description In log time mode, the 850 can set every 1 second, 5 second, 15 second, 30 second, 5 minute, or 10 minute to log one point.
2.5.6.3 Smart Log Setting When the smart log function is start, the 850 will into different log manner and depend on speed of hour. FUNCTION BUTTON Detail Description MENU (TO LOW In low speed, you can press “ADJUST” button to select 4km/h, LOW SPEED SPEED) > ADJUST > 6km/h, 8km/h, and 15km/h. ENTER MENU (TO HIGH In high speed, you can press “ADJUST” button to select 30km/h, HIGH SPEED SPEED) > ADJUST > 60km/h, 100km/h and 140km/h.
When you select “ON” and then press “ENTER” button. Please see below description. > 6km/h (LOW SPEED) Each 15sec record one point 60>Middle SPEED>6km/h Each 10sec record one point 60km/h(HIGH SPEED) > Each 5sec record one point 2.5.6.4 Log Manage Setting If you want to create a new track, you can select create a new file. The log file will produce different track in Photo Tagger software.
2.5.6.5 Unit Set FUNCTION BUTTON Unit setting ADJUST Detail Description Press “ADJUST” button, you can select km or mile unit for the 850. NEXT SECTION MENU Please press “MENU” button go to next section. 2.5.6.6 Default Set FUNCTION BUTTON Detail Description If you select “YES”, the 850 will recover to default setting and Recover to default ADJUST > YES or NO back to Battery, Satellite, Log memory Mode. And you select “NO”, the 850 will back to “DEFAULT”.
2.5.7 Connecting your handheld device with 850 Please refer to the user manual of PDA to enable the Bluetooth connectivity. Below, we provide a common procedure of software installation to set up your PDA. (For other PDA, the steps may be different. Bluetooth Manager is a popular program used on Bluetooth device.
A. Open “Bluetooth Manager” on your pocket pc, and establish a new connection. --> Explore A Bluetooth device ->Next Tap 850 GPS B.
C. (Optional) --> Select SPP slave->Next Finish D. Connect to Serial Port Profile (SPP) Slave --> Tap and Hold 850: SPP slave, Done Connect E.
1. Loading your GPS mapping or routing software You should have mapping software on your PDA/ Smartphone/ laptop or you need to install it before using the 850 for navigation. 2. Starting the application Select the correct COM port & baud rate within the application. Note: The Bluetooth device in most of the applications has an “auto-detect” feature so that you do not need to select the Baud Rate.
2.6 Helpful Tips - It’s better to turn off the 850 when you don’t use it, or the serial Flash's life can’t last long. - Some vehicles having heavy metallic sun protecting coating on windshields may affect GPS signal receptions - Driving in and around high buildings may affect GPS signal receptions. - Driving in tunnels or indoor park may affect signal receptions. - In general, any GPS receiver performs best in open space where it can see clean sky.
Chapter3. How to configure your GPS Record? The GpsView program only supports the Microsoft Windows based platform. 3.1 Driver Installation Before the USB connector plugs in your PC/ Laptop, please have your USB Driver Installation ready. (Install InstallDriver.exe driver for USB port from CD-ROM.) 3.2 GpsView software Open the GpsView software, please select correct COM port and Baud Rate (USB / Bluetooth :115,200bps) to configure GPS. 3.2.
3.2.2 Executing GpsView Program Click “Command” tap. Update Rate 1 ~ 5Hz is user configurable. And still more options for choice of NMEA output, DGPS…etc. all available through pull-down menus.
3.2.3 Download AGPS 1.
2. Open GpsView.exe→Check Baud Rate and Com port→click On 3.
4. Choice Update。 5. When Updating now…100%, click Enter complete。 [Note] When you use GpsView software download AGPS data, it only supports use Bluetooth connect to PC and 850.
Chapter 4 Using Photo Tagger software 4.1. Execute and install software utility Photo Tagger Complete GPS Photo Tagger and USB drivers installation (Refer to CD) 4.2. Google Earth If you computer is not yet installed with Google Earth. Google Earth has free download version, go download it in the internet first. For more information, please visit http://earth.google.com/. 4.3.
Appendix Appendix A. Locr GPS Photo With 850 and locr GPS Photo software, users are allowed to import geotagging adds information to photos. The position (latitude/ longitude) then be written into the EXIF header for the further application. Also, locr GPS Photo can integrated travel log and digital photos by date/ time to show photos on the map directly. Please find the installation file for Windows XP/ Vista in CD tool, or go to http://www.locr.com for further information.
32
Appendix B. Certification FCC Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Change or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
CE Notices Is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility (89/336/EEC), Low-voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC), the procedures given in European Council Directive 99/5/EC and 89/3360EEC. The equipment was passed. The test was performed according to the following European standards: - EN 300 328-2 V.1.2.1 (2001-08) EN 301 489-1 V.1.4.
Appendix C. Warranty Information Thank you for your purchase of GPS product from the company. The company warrants this product to be free from defects in materials and workmanship for one year from the date of purchase. The warranty for accessories is six months. The stamp of distributor or a copy of the original sales receipt is required as the proof of purchase for warranty repairs. The company will, as its sole option, repair or replace any components, which fail in normal use.
