MMDS Transceiver Operation Manual Copyright 2008, TRANSYSTEM, INC. All rights reserved TRANSYSTEM INC. No.1-2 Li-Hsin Rd.I Science-Based Industrial Park, Hsinchu, Taiwan Tel:+886-3-5780393 Fax:+886-3-5784111 e-mail: sales@transystem.com.tw website: www.transystem.com.
TABLE Chapter 1. Chapter 2. Chapter 3. OF CONTENTS General Information 4 1.1 Module Features and Specifications 4 Installation 5 2.1 Step by Step Installation 5 2.2 Connection to the Power Inserter and Cable Modem 8 2.3 Waterproofing Connections 10 Accessories 12 3.
Chapter 2. Installation 2.1 Step by Step Installation 2.1.1 Mounting Bracket Assembly Suite The following hardwares are suggested for mounting the Transceiver to the pole. A set of mounting bracket, one L type screw. Please contact TSI sales department for this accessory.
2.1.2 Step by Step Installation Step 1 – Attach sequence Left to right: Bracket , Mounting screw. Step 2 – How to Attach The concave of Bracket 2 is for holding onto the pole.
2.2 Connection to the Power Inserter and Cable Modem Connections to the Tranceiver are shown in diagram 2.2. Please note: ① The power inserter normally has 3 ports: DC Connect to wall adapter with RG-59 cable ANT Connect to the Transeiver TV Connect to Cable modem VERY IMPORTANT NOTICE! a. The power inserter should be correctly connected, or the Transeiver will not operate. b. Ensure that all wires and cables are hooked up before plugging into the AC adapter/power supply (i.e.
2.3 Waterproofing Connections Water-proofing is very important during installation of Transceiver. Please use the included water-proof asphalt tape to seal off the F-connector as shown below: ① After you plug in the coaxial cable into the F-connector, use the included water-proofing asphalt tape to seal off the F-connector from the bottom (i.e. the part close to Transceiver). Note that the tape must wrap up all the thread of the F-connector. ② The wrap up of the tape must be tight and sturdy.
③ The total width of the wrap-around is about 6cm, which corresponds to 7 to 8 rounds of tapes. * Warning: If you do not follow the above procedure, the Transceiver could become malfunctioning due to water leakage.
FCC Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. CAUTION: Change or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
TRX-200 Overview TRX-200 is TSI’s new generation transceiver for 2-way wireless broadband Internet application at 2574-2690 MHz band for down stream. It accepts an IF signal of 12~42 MHz from cable modem, upconverts the signal to 2500~2530MHz and transmits it back to the MMDS headend site. With its built-in automatic on/off switch, TRX-200 will enter sleep mode to eliminate the broadband noise when there is no data packet transmission.
