User Manual

Revision - 1.0
8
The cover consists of a PETG shield, two pan-head screws, two bottom screws (pan or flat depending
on mounting), a hex standoff and two wide washers.
Installing a new cover
Remove the side flaps covering the mounting holes of the case.
Insert the bottom screw through the mounting hole, loosely attaching the hex standoff to keep it from
falling. Using pliers or a socket, holding the hex standoff tighten the bottom screw tight. Report for
the other side.
Remove the protective cover from both sides of the PETG protective plate. Attach one washer onto
the top screw, insert the top screw through the PETG, and attached a washer on the bottom side.
Holding the washer against the PETG, insert the screw into one of the installed hex standoffs and
loosely secure. Repeat with the other side. Tighten down the two top screws to secure the PETG, the
cover is now installed.
If you need to replace or repair the cover, it can be removed by removing the top screw, being careful
to secure the washers while removing the screw. Only replace with parts supplied from TRIG.