User's Manual

1
A
NRD1 Manual - PRELIMINARY
FCC Information
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
A
PPENDIX
–
FCC
/
IC INFORMATION
FCC / IC Declarations
The M2 Utility Radio Tranceiver is an
approved intentional radiator device under FCC
15.247 and Industry Canada under RSS-210.
THIS DEVICE COMPLIES WITH PART 15
OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
The NRD1 Relay is a self-contained unit and
access to its circuitry by an end user, other than
for installation, wiring or replacement of the
battery, is not intended. The supplied whip
antenna is the only antenna authorized for use
with the NRD1. Changes or modifications not
expressly approved by Transparent
Technologies or use of the radio other than the
purposes described herein voids the user's
authority to operate the equipment.
Industry Canada product labeling.
“IC” before the equipment certification number
only signifies that the Industry Canada
technical specifications were met.