Installation Guide
Move the assembled unit to its final location.Final hook up of the
supply lines and drain system can now be completed.
Problem Possible Cause Possible Cause
There are leaks
underneath the handle.
The aerator leaks or has
an inconsistent water
flow pattern.
There are leaks from
the hose underneath
the deck.
The water pressure is
low.
There is no hot or cold
water.
The screw nut has come loose and the
o-ring on the cartridge is dirty or damaged.
The aerator is dirty or misfitted.
The cartridge may be clogged.
The supply hose and outlet hose connection
may be loose.
The connector underneath the deck is
clogged with debris.
The aerator is clogged.
The water supply hose was accidentally
kinked during installation and is limiting
the water flow through.
Tighten the screw nut. Clean or
replace the cartridge or o-ring.
Remove the aerator and check
for debris in the aerator screens.
Remove the cartridge and check
for debris.
Ensure the aerator is properly
installed.
Tighten the connection of the
hoses.
Turn off the water supply and
disconnect the connector
/ aerator.
Unscrew the connector / aerator
and clean under running water.
Screw the connector / aerator
back.
Test water flow. If water
pressure is still low then replace
the connnector / aerator.
Reinstall the water supply hose.