Installation Guide

ManualsBrandsTransolid ManualsKitchen SinksMUDD32219

Create your own template.

1. Using a framing square, draw a line from front to back on the bottom of the countertop, indicating

the location of the center of the sink.

Draw a line parallel to the front edge of the countertop, indicating how far back the sink should be

located. Typically the setback is 2” to 2-1/2” from the front of the counter, depending on the counter-

top overhang, the type of sink bowl and the size of the sink deck.

To create a template, turn the sink upside down on the piece of plywood and draw around it. Or

place template transfer paper or cardboard template on plywood. NOTE: paper and cardboard tem-

plates are supplied only as a guide. Using the actual sink ensures a more accurate cutout.

Mark the centerpoint of the sink on the template. If you are using a 5/8” template guide on your rout-

er, draw another line 1/16” outside the sink outline (this allows for the 5/8” template guide). If you are

using other cutting methods, adjust accordingly.

CAUTION: Be sure to cut on the inside of the template line to obtain the correct overhang.

Cut the plywood template, paying particular attention to the corner radius.

2. Make the sink cutout. Find the center of the sink template and

align it with the center mark drawn on the countertop. Place the

template with the front edge along the front edge line drawn on the

countertop. Secure the plywood template to the countertop using

6” bar clamps. Place the router over the plywood template and cut

around it, making sure the router follows the edge of the template.

This creates the sink cutout. Finish the inside of the sink cutout

according to the recommendations of the countertop material supplier.

To attach the undermount clips continue to Step 3. on previous page.

LEGAL DISCLAIMER

All technical data and information provided in this publication is done as a public service to customers of Transolid

and consumers of our products.

All names, designs, and model numbers of products are trademarks of Transolid

. Prices and specications of Transolid’s products are subject to

change without notice or obligation. Transolid

may also change or discontinue models of its products without notice or obligation. While Transolid

endeavors to provide you with accurate information and descriptions of its products, accuracy and completeness cannot be guaranteed. Transolid

is not responsible for, nor does it have any liability for any mistakes or typographical errors, including liability for incidental, consequential, or special

damages. All products should be inspected and measured promptly upon delivery and certainly before any improvements or alterations are done in

anticipation of or preparation for installation. Transolid

assumes no liability for the use of such information or for any damages incurred through its

use or application.

Nothing contained in this publication is to be construed as contractual or providing any form of warranty or representation on the part of Transolid

TRANSOLID

MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABI-

LITY OR OF FITNESS FOR A PARTICULAR PURPOSE, AS TO THE INFORMATION CONTAINED HEREIN OR THE PRODUCTS DESCRIBED

HEREIN.