Installation Guide

ManualsBrandsTransolid ManualsDrop-in Kitchen SinksRadius All-in-One Drop-in Granite 33 in. 1-Hole 1-3/4 in. D-Shape Double Bowl Kitchen Sink in Cafe Latte

INSTALLATION INSTRUCTIONS

TOP MOUNT

silQgranite

SINKS

These instructions are for installing Transolid

top mount silQgranite

sinks. Top

mount sinks (also known as drop-in sinks) are installed from above the countertop

and sealed to the top of the counter. If you are installing another type of sink, such

as Undermount sink which is installed below the counter, please refer to instructions

specically for those sinks.

ATTENTION INSTALLER:

Transolid

recommends that all countertops be cut by an approved or certied install-

er and that the sinks be installed by the installer whenever possible. The countertop/

sink unit ideally should installed as one on the jobsite.

Transolid

is not responsible for sink or countertop if damaged during installation.

Remember, it is your responsibility to follow all local plumbing and building codes.

Inspect sink for damage prior to beginning installation. Do not install a damaged unit.

The warranty will be voided if these installation instructions are not followed.

Templates are supplied only as a guide. The physical use of the sink will ensure a

more accurate cut-out.

The instructions that follow are for installing a Transolid

top mount stainless steel

sink. Be sure to read all instructions completely before beginning installation.

Tools and Materials You will Need

Eye protection (safety glasses/goggles)

strongly recommended

Silicone adhesive sealant (not supplied)

Masking Tape

Ear protection strongly recommended Slotted screwdriver

Top mount (drop-in) template supplied by

Transolid

Ruler/Tape measure

Pencil (not permanent marker)

Top mount (drop-in) clips supplied by Transolid.

(NOTE: these come with the sink and are in a

separate plastic bag. Please make sure they

are not thrown away with the carton.)

Drill and drill bit

1-1/4” Hole Saw

Saber Saw (if countertop cutout is required)

LEGAL DISCLAIMER

All technical data and information provided in this publication is done as a public service to customrs of Transolid

and consumers of our products.

All names, designs, and model numbers of products are trademarks of Transolid

. Prices and specications of Transolid’s products are subject to

change without notice or obligation. Transolid

may also change or discontinue models of its products without notice or obligation. While Transolid

endeavors to provide you with accurate information and descriptions of its products, accuracy and completeness cannot be guaranteed. Transolid

is not responsible for, nor does it have any liability for any mistakes or typographical errors, including liability for incidental, consequential, or special

damages. All products should be inspected and measured promptly upon delivery and certainly before any improvements or alterations are done in

anticipation of or preparation for installation. Transolid

assumes no liability for the use of such information or for any damages incurred through its

use or application.

Nothing contained in this publication is to be construed as contractual or providing any form of warranty or representation on the part of Transolid

TRANSOLID

MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY

OR OF FITNESS FOR A PARTICULAR PURPOSE, AS TO THE INFORMATION CONTAINED HEREIN OR THE PRODUCTS DESCRIBED HEREIN.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS TOP MOUNT silQgranite® SINKS These instructions are for installing Transolid® top mount silQgranite® sinks. Top mount sinks (also known as drop-in sinks) are installed from above the countertop and sealed to the top of the counter. If you are installing another type of sink, such as Undermount sink which is installed below the counter, please refer to instructions specifically for those sinks.
PAGE 2
INSTALLATION INSTRUCTIONS - TOP MOUNT silQgranite® SINKS 1. Cut-out Area Masking Tape 2. 4. 3. Drill starter hole inside of cut-out line 5. Cut inside of line. NOTE: Drill starter hole inside of cut-out line Sink installation recommended for professional installers only. Drop-in side: 1. Select the drop-in kitchen sink template that applies to the model sink you are installing. Cut out the inside of the template and discard the cut-out portion.
PAGE 3
INSTRUCCIONES DE INSTALACIÓN Fregadero de silQgranite® instalado en la parte superior del mostrador Estas instrucciones son para instalar fregaderos de silQgranite® de montaje superior Transolid®. Los fregaderos de montaje superior se instalan desde arriba de la encimera y se sellan en la parte superior del mostrador. Si está instalando otro tipo de fregadero, como el fregadero Undermount que se instala debajo del contador, consulte las instrucciones específicas para esos fregaderos .
PAGE 4
INSTRUCCIONES DE INSTALACIÓN Fregaderos de silQgranite® instalados en la parte superior del mostrador 1. El Area Corrtado La cinta adhesiva protectora 2. 3. Taladre un agujero para comenzar dentro de la linea para cortar 4. 5. Empleando una sierra sable, corte por dentro de la linea para cortar. Haga la prueba si cabe con la tarja Taladre el agujero inicial al reverso Termine taladrando el agujero de la superficie Instalación de fregadero recomendada sólo para instaladores profesionales.