Installation Guide

ManualsBrandsTransolid ManualsKitchen SinksFUSE302010

www.transolid.com

LEGAL DISCLAIMER

All technical data and information provided in this publication is done as a public service to customrs of Transolid

and consumers of our products. All

names, designs, and model numbers of products are trademarks of Transolid

. Prices and specications of Transolid’s products are subject to change

without notice or obligation. Transolid

may also change or discontinue models of its products without notice or obligation. While Transolid

endeavors

to provide you with accurate information and descriptions of its products, accuracy and completeness cannot be guaranteed. Transolid

is not respon-

sible for, nor does it have any liability for any mistakes or typographical errors, including liability for incidental, consequential, or special damages. All

products should be inspected and measured promptly upon delivery and certainly before any improvements or alterations are done in anticipation of

or preparation for installation. Transolid

assumes no liability for the use of such information or for any damages incurred through its use or application.

Nothing contained in this publication is to be construed as contractual or providing any form of warranty or representation on the part of Transolid

TRANSOLID

MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABI-

LITY OR OF FITNESS FOR A PARTICULAR PURPOSE, AS TO THE INFORMATION CONTAINED HEREIN OR THE PRODUCTS DESCRIBED

HEREIN.

3. Make the Template and Cutout

Depending on the installation option, make the proper cutout of the countertop. Transolid

rec-

ommends a 1/4” reveal on 3 sides when installed undermount style. For a ush mount or built-up

installation, cut countertop along the outside line of the sink prole. The front end of Transolid

reclay farmhouse sinks are designed to be installed 3/4” extended out beyond the front end of the

countertop. Cut countertop accordingly.

No template is provided due to the custom nature of each application and installation. The actual

sink is used as the template guide for each installation type. After centering the sink and allowing for

any faucets and backsplashes, use a pencil to outline the sink as your guide for the cutout, allowing

for reveal before the actual cutting.

3. Set the Sink

Set the sink on top of the cabinet or into the cab-

inet front cutout. Apply sealant if necessary as a

gasket between te sink and the cabinet.

4. Install the Countertop

Carefully clean the bottom of the countertop and

the top ange of the sink with denatured alcohol.

Apply a bead of silicone adhesive (not supplied)

around the edge of the sink. Place the countertop

onto the sink, and remove excess sealant from

the lip of the sink or any other surfaces with a

cleaner recommended by the manufacturer of the

adhesive sealant.