Specifications

DIP SWITCHES
MODE SWITCHES
SWITCH 1 – PROG (PAIR) – Use for programming TX-100 to XRE-100
SWITCH 2 – Not used
SWITCH 3 – Not used
SWITCH 4 – Not used
The behavior of the relay(s) is controlled by Dipswitch 5 & 6.
SWITCH 5 = momentary or latching
SWITCH 6 = single or dual relays
PROGRAM/TEST BUTTON:
To program turn DIP switch 1 to the on position in both the XRE-100 and TX-100. With both DIP switches turned on
press the TX-100 transmit button.
If done correctly the XRE-100 will flash yellow status LED 3 times and TX-100 will flash green LED 3 times.
RELAY DELAY POTENTIOMETER:
Full counter clockwise is 1/2 second delay from relay 1 to relay 2 activation. Full clockwise is 10 second delay from
relay 1 activation to relay 2 activation. To activate make sure DIP switch 6 is set to ON in the XRE-100.
1
2
3
DIPSWITCH 5 DIPSWITCH 6 FUNCTION
OFF OFF
ON OFF
OFF ON
OFF OFF
8