Switch User Manual

Port Control

Change the port status

• Select the port by scroll the Port column

• State: Disable or enable control of this port

• Negotiation: Set auto negotiation mode is Auto, Nway (specify the speed/duplex on this

port and enable auto-negotiation), or Force

• Speed: Set the speed of the port

• Duplex: Set full-duplex or half-duplex mode of the port

• Flow control: Set flow control function is Symmetric or Asymmetric in Full Duplex mode.

The default value is Disable

•

And then, click

Apply

button to apply all configuration

• When user select the port, user can see port current configure shows in below column

Port Control interface

Switch Setting

Assigning the system name, location and view the system information

• System Name: Assign the name of switch. The maximum length is 64 bytes

• System Description: Display the description of switch. Read only cannot be modified

• System Location: Assign the switch physical location. The maximum length is 64 bytes

• System Contact: Enter the name of contact person or organization

• Firmware Version: Display the switch’s firmware version

• Kernel Version: Display the kernel software version