Manualshelf

Network Hardware User Manual

ManualsBrandsTransition Networks ManualsCooktopINDUSTRIAL DEVICE SERVER RS-232-TO-100BASE-FX
21222324252627282930
Transition Networks SDSFE31xx-100 Industrial Device Server
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
16
Connecting an alarm fixture, continued
Fault
indications
Wire the relay contacts to any warning light or audible alarm in the factory or control
room. Then when a fault occurs, the relay contacts close, sending a signal to activate
an external alarm or turn ON a light, indicating a fault. An alarm will occur under
the following conditions:
• Any link failure cable disconnected, device break down .....)
•
PWR/RPS power failure:
o Power wires are disconnected, power source malfunction
o Input power is out of this range: 9 – 48V