™ ™ Ethernet Pocket Hub Model 0401 (E-TBT-HB-0401) 7345.C For assistance in installing, using, or maintaining the TRANSITION Networks Model 0401 Ethernet Pocket Hub, contact TRANSITION Networks Technical Support at: (800) 260-1312 or contact your local distributor.
The sole purpose of this remedy shall be provided the customer with the replacement or repair of non-conforming goods in the manner described in this Warranty statement. This exclusive remedy shall not be deemed to have failed of its essential purpose so long as TN is willing and able to repair or replace the defective item(s) or refund the purchase price. TN reserves the right to inspect products claimed to be defective under warranty either at the customer’s location or at TN’s plant.
Warranty Statement A. Five Year Warranty Transition Networks, Inc. (TN) warrants, for a period of five years, that TN products (with the exception of power supplies and fans that TN warrants for two years) will be free from defects in materials and workmanship, and will be in conformity with TN’s specifications. TN’s warranty on products manufactured by or assembled for TN in accordance with a customer’s specifications, is a five-year warranty that the goods conform to such specifications.
Model 0401 Ethernet Pocket Hub Specifications 1. INTRODUCTION This guide is intended for the system or network administrator responsible for installing and monitoring a TRANSITION Networks 0401 Ethernet Pocket Hub. A working knowledge of local area network (LAN) operations, including familiarity with communications protocols used on interconnected LANs, is assumed. Dimensions 4.80" X 2.77" X 0.
. MAINTENANCE WARNING: DO NOT, UNDER ANY CIRCUMSTANCES, open and attempt to repair the 0401 Pocket Hub. Failure to observe this warning could result in personal injury or death from electrical shock. 0401 Ethernet Pocket Hub Connectors and Status LEDs RJ-45 Connectors Four (4) 10BaseT RJ-45 jack connectors are located at one end of the 0401 Pocket Hub. The RJ-45 jacks support connection to shielded or unshielded 100 ohm twisted pair 10BaseT cable.
2. SITE CONSIDERATIONS 4. OPERATION The site for the 0401 Ethernet Repeater Hub must provide: • AC power outlet for each Hub • Adequate ventilation • Standard environmental conditions • Isolation from electrical noise, including radio transmitters and broadband amplifiers, motors, high power electrical lines, or fluorescent light fixtures. Additionally: • The twisted pair cables should not run in the same conduit with power line cables. • Phone lines should be separated from data cables.
Connecting Pocket Hub to Powered PC Ensuring Correct 10BaseT Configuration NOTE: The 0401 Pocket Hub is powered ON when connected, through the AUI connector, to a powered PC. After the AUI is connected to a PC, the green Power LED is illuminated. The 10BaseT cable and RJ-45 jacks for Hub to Terminal connections must be configured as straight through. The 10BaseT cable and RJ-45 jacks for Hub to Hub connections must be configured as crossover. To power the 0401 pocket hub: 1. Locate or build IEEE 802.
Connecting Pocket Hub to 10BaseT Cable 3. INSTALLATION The 0401 Ethernet Pocket Hub is designed to draw power from the AUI port of a PC or hub. The 0401 Pocket Hub MUST be connected to an AUI port BEFORE the 10BaseT ports are allowed to be powered and active. NOTE: 0401 Ethernet Pocket Hub Link Integrity cannot be disabled. All devices connected to the Pocket Hub MUST have link functions enabled. To install the 0401 Ethernet Pocket Hub: • • • To connect 10BaseT Cable to Pocket Hub RJ-45 connectors: 1.
