Network Hardware User Manual

CPSMM-120
2
24-hour Technical Support: 1-800-260-1312 - International: 00-1-952-941-7600
CPSMM-120 Single-Slot Master Management Module
The figure below illustrates the components of the CPSMM-120 management
module:
•A panel fastener screw that secures the management module to the
Pointsystem™ chassis.
• PWR (power), LINK, RX (receive), and TX (transmit) LED indicators.
•A reset switch, which resets ONLY the CPSMM-120 management module
(not the chassis in which it is installed).
• A 10Base-T RJ-45 Ethernet port, through which the management module
communicates, using the Ethernet network, with a remote Network
management Station (NMS) or with a Telnet connection
•A DB-9 serial port, through which the management module
communicates with the command-line interface.
RX
TX
LNK
PWR
CPSMM120
SERIAL
10BASE-T
R
E
S
E
T
LEDs
Panel Fastener Scre
w
Reset Switch
RJ-45 Ethernet Port
DB-9 Serial Port
Application CD
The enclosed application CD contains:
1. CPSMM100 Firmware, which includes:
• a Command-Line Interface (CLI),
• a Telnet server,
• a Web browser, and
• an SNMP agent.
2. FocalPoint™ 2.0 Management Application, which can be used to
monitor and control the PointSystem™ chassis from a remote location.
3. A User’s Guide, which describes in detail how to use both the
CPSMM100 firmware and the FocalPoint™ 2.0 management application.
[e-mail] -- Click the “Transition Now” link for a live Web chat.
3
Installing the CPSMM-120
The CPSMM-120 management module is designed to be installed into a
Transition Networks PointSystem™ chassis to enable network management of
any media converter slide-in-modules installed in the chassis. The following
chassis are available:
• CPSMC0200-100, 2-slot PointSystem™ chassis
• CPSMC0800-100, 8-slot PointSystem™ chassis
• CPSMC13xx-100, 13-slot PointSystem™ chassis
• CPSMC18xx-xxx, 18-slot PointSystem™ chassis
• CPSMC19xx-100, 19-slot PointSystem™ chassis
Redundant Management
Two CPSMM-120 management modules may be installed in the same
network. In this set-up, the two modules auto-negotiate; where one is the
primary module while the other is in stand-by mode. If the primary module
fails, the stand-by module automatically takes over and manages the network.
Replacing the CPSMM-120
The CPSMM-120 can be hot-swapped, that is, the CPSMM-120 can be
replaced while the PointSystem™ chassis is powered. However, please note
that:
• If there are two management modules installed in the same network, the
stand-by module will continue to manage the network while the primary
module is replaced. Also, the stand-by module will retain all network
settings.
• If there is only one management module installed, all SNMP management
operations will cease once the module is removed. The newly installed
management module must be reconfigured to resume network
management.
For more information on installing and replacing the CPSMM-120, see the
user’s guide for the chassis in which the module will be installed. The chassis
manuals can be found on the Transition Network website at:
www.transition.com.
RX
TX
LNK
PWR
RESET
The CPSMM-120 management module is installed
in one of the Transition Network PointSystem
TM
chassis.
(Configuration for the 13-slot, 18-slot, or 19-slot chassis is shown here.)