IONPS-A AC Power Module User Manual 33423.
IONPS-A, AC Power Module Table of contents Cautions and Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Cautions and warnings in this manual . . . . . . . . . . . . . . . . . . . . . . . . .3 Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Power Module component identification . . . . . . . . . . . . . . . . . . . . . . .
IONPS-A, AC Power Module Description Description — continued Transition Networks’ IONPS-A, AC Power Module can deliver power or provide optional, redundant AC power to an ION219-A chassis. See the ION219-A chassis manual #33421. You can download the manual @ www.transition.com, then click on Product/Product Finder. Power Module component identification Notices • The IONPS-A, AC Power Module must be installed by qualified technical personnel only.
IONPS-A, AC Power Module Installation — Continued Installation — Continued Installing an optional Power Module into the ION chassis Installing an optional Power Module into the ION chassis — continued WARNING: Do not connect the Power Module to an external power source before installing it into the chassis. Failure to observe this warning could result in an electrical shock. 2. If necessary, remove the grounding hardware from the chassis before installing or removing the Power Module. See Figure 3.
IONPS-A, AC Power Module Installation — Continued Installation — Continued Installing an optional Power Module into the ION chassis — continued Installing an optional Power Module into the ION chassis — continued 4. Position the Power Module at the chassis slot, as shown in Figure 5. 6. Insert the two screws to mount the Power Module to the chassis. Connecting the Power Module to external power To connect external power to the IONPS-A, AC Power Module, do the following: Chassis 1.
IONPS-A, AC Power Module Maintenance — Continued Maintenance Installing the Power Module — continued Replacing the Power Module WARNING: Do not connect the Power Module to the external power source before installing it into the chassis. Failure to observe this caution could result in equipment damage and/or personal injury or death. 6. Locate the new Power Module. 7. Push the power ON/OFF switch to the OFF position. 8. Position the Power Module at the chassis slot, as shown in Figure 10.
IONPS-A, AC Power Module Maintenance — Continued Technical Specification Replacing the fuse For use with Transition Networks Model IONPS-A, AC Power Module. CAUTION: Ensure that the IONPS-A, AC Power Module has been disconnected from the external power source and the ON/OFF switch is at “0.” Failure to observe this caution could result in damage or failure of the Power Module. Dimensions: 8.3" x 8.4" x 2.7" (211 mm x 211 mm x 69 mm) Weight: 4 lb. (6.
IONPS-A, AC Power Module Troubleshooting If the Power Module fails, isolate and correct the failure by determining the answers to the following questions and then taking the indicated action: 1. 2.
Compliance Information FCC Regulations This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
