Instructions

Discard Original

Actuator Feed Limit

Page 4

©TransGo 2019

02/12/21

TransGo # AFL-G2-TK Tool Kit.

No Groove

1 Groove

2 Groove

6T70 Gen2

6T40 Gen2

6F35 Gen2

New AFL Valve

Re-Use

Read This First:

Due to the new vent locaon in a Gen 2 Rear body and the amount of

bore wear seen, the AFL leak can not be xed with a “drop-In” soluon

for the Gen 2 Actuator Feed Limit Valve. To repair the AFL Valve bore

a tool kit is also required: TransGo # AFL-G2-TK Tool kit

Rear Body ID and Repair

Gen 1 Rear body has No Exhaust here

Gen 2 Rear body has Exhaust here

This kit only ts Gen 2 VB’s

Drop in sleeves work great on

Gen 1 casng. Drop in sleeves

wont x a worn Gen 2 casng.

Step 2. Aer reaming, clean the bore and the new AFL Valve

furnished in this kit. Make sure the valve is free in the bore.

Install the New AFL Valve and reuse original spring and retainer.

Tool Kit ts 3 dierent transmissions, just use the correct reamer guide.

Fits All Gen 2 Vb’s 6F35’s, 6T40’s and 6T70’s.

Step 1. The 6T70 Gen 2 uses the “No Groove” reamer guide.

Place the no groove guide into the bore ll it stops, with the

stepped end out as shown. Use lots of WD-40 and low speed on

your favorite portable drill, let the reamer do the cung unl it

booms in the bore. Don’t force the reamer, bore nish and

Reamer life require a slow inward movement and lots of WD 40.