Instructions

Manual
= 10 Check balls
Main Body Repairs Connued (Front Side)
Page 3
Orange
New Scarf Ring
Original
Shi Slug
TCC Regulator
Original
Retainer
Original
End Plug
Discard Original
Valve and Spring
©TransGo 2019 02/12/21
Step 1
Discard original TCC Regulator Valve and spring. Clean the New TCC Regulator Valve
provided and test t it into the clean VB bore. If it moves freely, remove it and put a
small dab of assembly gel into the groove of the new valve followed by the NEW
Scarf Cut Ring. Now roll the small O-ring provided on top of the scarf cut ring and
place it in the freezer for 15 minutes. This will “size” the ring into the groove. Note:
The O-ring is only used as a sizing tool.
To install, roll the O-ring o the valve and set it aside. Insert the NEW Orange Spring
into the hollow end of the new valve and insert new valve and spring into the bore
while it’s sll cold, followed by the original Shi Slug, End Plug and Retainer. It will
go right in if the outer diameter of the ring is ush with the new valve.
Never force the valve in. Once you install the valve and ring– DO NOT REMOVE IT!