Instruction Manual

Stem
B
Accum valve
C
WHITE
Plain
Washer
Piston
Step 2. 2nd Accum Piston.
Install washer and the PLAIN
spring furnished.
Retainer
End plug
Upper Valve Body
Upper Valve body
Here’s Why: Edge A on the valve
hits partition at C. This deforms the
bore which sticks the valve at land B.
Step 1. Remove the accum valve.
Chamfer partition as shown at bottom
of page. Clean the bore. Reinstall
valve. Install the WHITE spring, end
plug and retainer.
You’ll love the 1- 2 shift.
Short--Smooth- -No bangs
By HAND, make a slight chamfer
in valve bore at “C” using a sharp
7/16” or 15/32” drill.
Here’s how to fix it:
Checkballs:
Five Steel .214 to .218
Don’t use plastic balls.
Use some Vaseline to keep the
checkballs in place NOT grease.
Turn 7/16” or 15/32”
drill by hand in bore.
Hello Mechanic:
Install accumulator valve first.
Then install the flat washer on
the stem of accum valve, then
the remaining parts as shown.
Page 2
Cutaway side view
A
Pilot Valve
YELLOW
Step 3. Pilot valve.
Install YELLOW spring.
SK RE4FO3A 4 May 2011