User Manual

Follow these instructions to clean the emitter points:

1. Remove the front grill.

Moisten a swab or wiping cloth in the IPA solution.

3. Swab or wipe the emitter points until they are free of

particles.

4. Make certain the emitter points are straight and parallel

to the plane of the fan.

5. Replace the front grill.

6. Make sure the emitter points are dry before powering the

ionizer again.

Emitter Point Replacement

The IN5130 uses tungsten alloy precision etched emit-

ter needles. Contact Transforming Technologies for infor-

mation about ordering replacement emitters. The part num-

ber for emitters is listed below:

Replacement part Part Number

Tungsten replacement emitters 22-6423

Because the IN5130 high voltage output is AC, emitter

erosion from the ionization process on the electrodes is

minimal. Unless physically broken or stressed, the IN5130

emitters should last the life of the ionizer.

Follow these instructions to remove the emitter points:

1. Turn off and disconnect the unit from the AC power.

2. Remove the front grill.

3. Unscrew the threaded emitter point using a needle nose

pliers.

4. Replace and tighten the new emitter using the same

tool. Do not over-tighten.

5. Repeat steps 3 and 4 as required.